Interlink-electronics Micro Joystick Manuel d'utilisateur télécharger pdf (Page 14)

www.interlinkelectronics.com

MicroJoystick

Integration Guide

The hole/indentation should be centered on the MicroJoystick’s stick. Alternatively, a spacer can

be designed with a hole/indentation and mounted in-between the MicroJoystick and the mounting

surface. For more information on this mounting method, please refer to the Figure 4, “Using

Captuator for Registration with Opened Support Plate.”

To install the MicroJoystick, inspect the mounting surface, MicroJoystick and optional spacer to

ensure that they are clean and free of contaminants (e.g., dirt, dust, hair, etc.). Then place the

optional spacer on the mounting surface, and place the MicroJoystick on the mounting

surface/spacer and install the screws. Use care to torque the screws evenly and ensure that they

only thread into one surface (i.e., either the MicroJoystick’s base or the mounting surface,

depending on whether installing the screws from the bottom or top).

Note: When mounting the MicroJoystick to a flat surface, please carefully review the ESD

concerns described in section 5.2.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Pas de commentaire

Interlink-electronics Micro Joystick Manuel d'utilisateur Page 14